Promac 213A Mode D'emploi page 8

II PARTS
4. Install table and clamp with bolt. Fig. 6
5. Attach the Head Assembly
* Carefully put the head assembly over column and
slide it onto column into position. Align head frame
with table and base.
* Fix set screws in right side of head to lock head into
position then tighten with Allen wrench. Fig. 7
6. Install the Feeding Handles.
* Screw knob on each feeding handle, install them into
hub of pinion shaft. Fig. 8
7. Attach the Arbor and Chuck
7‐1 Insert abor into spindle first. Pull feeding handle
down to press abor inward. Fig.9
7‐2 Open chuck jaws completely by turning attached
chuck key counter clockwise to the end. Put a piece
of scrap wood on the table to protect chuck nose.
7‐3 Install chuck to the arbor tightly. Fig.10
8. Install knob and screw of upper pulley cover. Fig.11
8/47
213A