Pentair IntelliFlo VF Manuel D'installation Et D'utilisation page 7

5
IMPORTANT SAFETY PRECAUTIONS
WARNING — Pumps improperly sized or installed or used in applications other than for which the
WARNING — The pump can produce high levels of suction within the suction side of the plumbing
WARNING — In a domestic environment, this product may cause radio interference in which case
WARNING — Do not install on IT (insulated terra) mains network (marine applications)
WARNING — Fitting a non-return valve after the pump on the installation will prevent the impeller of
NOTE — If required by local building codes, the pump is to be supplied by an isolating transformer or supplied
through a residual current device (RCD) having a residual operating current not exceeding 30mA.
NOTE — Use only RCD/GFCI suitable for protecting equipment with a DC current content in the fault current.
• These instructions contain information for a variety of pump models and therefore some
instructions may not apply to a specific model. All models are intended for use in swimming
pool applications. The pump will function correctly only if it is properly sized to the specific
application and properly installed.
General Warnings
• Never open the inside or the drive motor enclosure. There is a capacitor bank that holds a 230
VAC charge even when there is no power to the unit.
• The IntelliFlo VF pump is not submersible
• The IntelliFlo VF pump is capable of 33 m
programming to limit pumps performance potential with old or questionable equipment
• Code requirements for the electrical connection differ from state to state. Install equipment in
accordance with the National Electrical Code and all applicable local codes and ordinances.
• Always Press the Stop button and disconnect the communication cable before performing
maintenance
IntelliFlo VF Installation and User's Guide
pump was intended can result in severe personal injury or death. These risks may
include but not be limited to electric shock, fire, flooding, suction entrapment or severe
injury or property damage caused by a structural failure of the pump or other system
component
system. These high levels of suction can pose a risk if a person comes within the close
proximity of the suction openings. A person can be seriously injured by this high level
of vacuum or may become trapped and drown. It is absolutely critical that the suction
plumbing be installed in accordance with the latest national and local codes for swimming
pools.
supplementary mitigation measures may be required.
unwinding and is strongly recommended.
/h or 31 m of head; use caution when installing and
3
(continued)