Manual Rpm Mode - Pentair IntelliFlo VF Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 138
14
Use Manual Mode to meaure and test the requirements of each flow-operated device in your pool system,
and record your results for later setup in the IntelliFlo's menus. See "Menus" on
instructions.
To operate IntelliFlo in manual mode:

Manual RPM Mode

1. Ensure that the green power LED is on.
2. Press the Manual button. Press the Start/Stop button. "MANUAL RPM" will appear in the top
left corner of the display, indicating that the pump is in Manual RPM Mode.
3. Use the Up and Down arrow buttons to view the screens below:
POWER (Watts): Displays power to the motor shaft in continuous watts
ACTUAL SPEED (RPM): Displays pump speed in RPM
FLOW (m
the "Set FLOW" screen (See "To Change the Speed and Flow" on the following page.).
As long as the IntelliFlo is in MANUAL RPM Mode, the programmed, or "commanded",
flow —not the actual flow—will appear in the Flow screen. To view the actual flow,
switch from Manual RPM Mode to Manual Flow Mode (See "Manual Flow Mode" on the
following page.).
Set SPEED (RPM): Allows you to set IntelliFlo to run at a continuous pump speed
Set FLOW (m
to change speed to manage the flow rate based on system changes
MANUAL RPM
POWER
IntelliFlo VF Installation and User's Guide
/h): Displays commanded flow. Will read "0" unless a value is programmed in
3
/h): Allows you to set IntelliFlo in Manual Flow Mode to allow the pump
3
®
12:15
MANUAL RPM
1000.RPM
15.W
ACTUAL.SPEED
RUNNING
RUNNING
®
®
12:15
MANUAL RPM
12:15
0 m³/h
FLOW
RUNNING
page 21
®
MANUAL RPM
12:15
MANUAL RPM
1000.RPM
12m³/h
Set SPEED
Set FLOW
RUNNING
RUNNING
for detailed
®
12:15

Publicité

Table des Matières
loading

Table des Matières