M.o. Flo Operation; Wave And Pulse Setup - Pentair IntelliFlo VF Manuel D'installation Et D'utilisation

42
Features Menu (Continued)
4. To change a setting, press the Left and Right arrows to select which digit to modify, then use the
Up and Down arrows to change the selected digit.
5. When you are done, press the Enter button to shave the changes. To cancel any changes, press the
Escape button to exit mode without saving.

M.O. Flo Operation

Like Feature 3-9, M.O. Flo functions as part of the filter cycles programmed in the Filter menu, and
IntelliFlo must be in Filter Mode for M.O. Flo feature to operate. M.O. Flo cannot be operated on an "on
demand" basis. If Enabled is selected in the M.O. Flo "Activation" setting , M.O. Flo will start and stop
at the times programmed in the Setup Menu whenever IntelliFlo is in Filter Mode. If Disabled is selected
in the "Activation" setting, IntelliFlo will not run the M.O. Flo feature.

Wave and Pulse Setup

To access the Wave or Pulse menus:
1. Ensure that the green power LED is on and the pump is stopped.
2. Press the Menu button. "Pool Data" is displayed.
3. Use the Up and Down arrow buttons to scroll to the "Features" menu item. Press the Select
button to select it. "Feature 1" is displayed. Use the Up and Down arrow buttons to scroll to the
"Wave" or "Pulse" menu item. Press the Select button to select it.
a)
To choose whether the Wave or Pulse feature will be Disabled or Enabled:
Select button to access the "Activation" setting (Default Disabled). To change the setting,
use the up Up and Down arrow buttons to toggle between the Disabled and Enabled
options. Press the Select button to select one. Go to step 5, below.
b)
To specify the feature to which to link the Wave or Pulse feature: U
Down arrow buttons to scroll to the "Feature Linked" setting. Press the Select button to
access it (Wave default 1, Pulse default 2). To change the setting, see step 4, below.
c)
To set the maximum pump speed for the Wave or Pulse feature: U
Down arrow buttons to scroll to the"Set Max Speed" setting. Press the Select button to
access it (Default 3450 RPM). To change the setting, see step 4, below.
d)
To set the minimum pump speed for the Wave or Pulse feature: U
Down arrow buttons to scroll to the "Set Min Speed" setting. Press the Select button to
access it (Default 3400 RPM). To change the setting, see step 4, below.
e)
To set the period length for the Wave or Pulse feature: U
buttons to scroll to the "Period" setting. Press the Select button to access it (Default 10
seconds, or 0010). To change the setting, see step 4, below
IntelliFlo VF Installation and User's Guide
Press the
se the Up and
se the Up and
se the Up and
se the Up and Down arrow