Feature 1(2) Mode; External Control Mode; Intelliflo With Intellicomm Communication Center - Pentair IntelliFlo VF Manuel D'installation Et D'utilisation

20

Feature 1(2) Mode

Feature 1 and Feature 2 should be used to operate water features such as spas, automatic pool cleaners,
and waterfalls. At a press of the Feature 1 or Feature 2 button, IntelliFlo will run in this mode at the flow
rate and for the length of time programmed in the Vacuum Settings Menu.
34 and "Feature 1 or 2 Setup" on page 38 for more information on setting up Feature 1(2).
Once the Flow and Duration parameters for Feature 1(2) have been programmed in the Features 1(2)
settings menu, the operation of these features is controlled through the Feature 1 and Feature 2 buttons.
1. Press the Feature 1 or Feature 2 button, then press the Start/Stop button. IntelliFlo will activate
the feature, and the active feature LED will be lit until the feature has finished operation.
2. The "Feature 1" screen will display a countdown of the time remaining in the duration you
programmed for that feature. By using the Up and Down arrow buttons, you can switch between
screens displaying current flow, power usage in Watts (W), and pump speed in RPM.
The example below, shows Feature 1 activated with the flow setting of 12m
setting of 1 minute (0:01)
Feature 1
12m³/h
Set Flow
Feature 1 with flow settings of 12m
and time duration setting of 1 minute
programmed in "Feature 1 and 2" menu.
See page 34.

External Control Mode

IntelliFlo With IntelliComm Communication Center

The IntelliFlo can be connected to the Pentair IntelliComm Communication Center via an optional
communications cable (P/N 350122). The IntelliComm is equipped with four pairs of input terminal
connections which can be connected to IntelliFlo's Program 1(4) in the External Control menu (See page
44 for more information on setting up External Control.). Each of Program 1(4) is equipped with a "Set
Flow" setting for programming IntelliFlo's flow rate for that program. IntelliComm's input terminal
connections are actuated by 15 - 240 VAC or 15 - 100 VDC received from another device, usually a pool
heating system, prompting IntelliComm to send a serial command activating Program 1(4). The IntelliFlo
will then maintain the flow rate set for Program 1 until it receives a subsequent command, either via the
IntelliComm, or manually through the control panel.
IntelliFlo VF Installation and User's Guide
® ®
12:15 Feature 1 12:15
0 :0 1
Time Duration
/h,
3
See "Feature 1 and 2" on page
/h, and the time duration
3
FEATURE 1
1.MIN
REMAINING TIME
RUNNING
FEATURE 1 IN
OPERATION
LEDs lit

Feature 1 pressed
®
5:01
Time remaining in
minutes
Pump status:
running
LEDs lit

Start/Stop pressed