Menu Button; Menus - Pentair IntelliFlo VF Manuel D'installation Et D'utilisation

21
External Control Mode (Continued)
Additionally, Programs 1(4) are equipped with a "Time Delay Stop" setting which allows you to specify a
period of time for which IntelliFlo will continue to operate at the programmed flow rate after the voltage
has stopped. See
up IntelliComm.
If more than one input on the IntelliComm is active, IntelliComm will communicate the highest number to
the IntelliFlo pump. The IntelliComm will always communicate to pump address 1.
Note: The IntelliFlo control panel remains active when the IntelliFlo is connected to the IntelliComm.The
following table shows the wiring terminal descriptions for IntelliComm.
Terminal
Terminal name
number
1-2 Power supply
3-4
5-6
7-8
9-10
11 + Data: Yellow
12 - Data: Green

Menu Button

Use Intelliflo's menus to configure and set parameters for IntelliFlo's modes.
To access the IntelliFlo Menus:
1) Ensure that the pump is stopped.
2) Press the Menu button. "Pool Data" is displayed.
3) Use the Up or Down arrow button to scroll through the menu items. Use the Select button to select
a menu item. Press the Enter button to save a setting. Press the Escape button to exit the menu item
without saving the changes.
The IntelliFlo menus structure is shown on the following page.
IntelliFlo VF Installation and User's Guide
"External Control Setup with IntelliComm" on page 44 for more information on setting
Program 1 15 -240 VAC or 15 - 100 VDC
Program 2 15 -240 VAC or 15 - 100 VDC
Program 3 15 -240 VAC or 15 - 100 VDC
Program 4
RS-485
Ground
Voltage
100 - 240 VAC
15 -240 VAC or
15 - 100 VDC
-5 to +5 VDC
Terminals
Maximum
Phase type
current
100 mA 1 Input
1 mA* 1 Input
1 mA* 1 Input
1 mA* 1 Input
1 mA* 1 Input
5 mA 1 Output
Frequency
50/60 Hz
50/60 Hz
50/60 Hz
50/60 Hz
50/60 Hz
N/A