Vacuum Menu; Vacuum Mode Setup - Pentair IntelliFlo VF Manuel D'installation Et D'utilisation

46

Vacuum Menu

Vacuum Mode Setup

To access the Vacuum menu:
1. Ensure that the green power LED is on and the pump is stopped.
2. Press the Menu button. "Pool Data" is displayed.
3. Use the Up and Down arrow buttons to scroll to the "Vacuum" menu item. Press the Select button
to select it. "Vacuum Flow" is displayed.
a)
To set the flow rate for Vacuum Mode:
access the "Vacuum Flow" setting (Default 12 m
setting, see step 4, below.
b)
To set the duration Vacuum Mode: U
buttons to scroll to the "Vacuum Duration" setting. Press the Select
button to access it (Default 1 minute, or 00:01). To change the setting,
see step 4, below.
4. To change a setting, press the Left and Right arrows to select which digit to modify, then use the
Up and Down arrows to change the selected digit.
5. When you are done, press the Enter button to shave the changes. To cancel any changes, press the
Escape button to exit mode without saving.
IntelliFlo VF Installation and User's Guide
®
Vacuum 12:15
12m³/h
Vacuum Flow
Press the Select button to
/h). To change the
3
se the Up and Down arrow
®
VACUUM 12:15
0:01
VACUUM DURATION
®
MENU
8:09
Vacuum