Operating Modes; Manual Mode; Metering The System - Pentair IntelliFlo VF Manuel D'installation Et D'utilisation

13
This section describes how to use the IntelliFlo VF operator control panel to set up the pump's operating
modes.
IntelliFlo Operating Modes: The operating mode buttons are Manual Mode, Filter Mode, Backwash
Mode, Vacuum Mode, Feature 1, and Feature 2. Feature 3 through 9 are set up in the Features settings
menu. For more information on Feature 3-9, see "Feature 3-9" on page 34, and "Feature 3-9 Setup" on
page 39.
External Control Mode is activated and operated through the IntelliComm communication center. See
"External Control Mode" on page 20 for more information on operating the IntelliFlo by remote control.
IntelliFlo Menu Button: Use the Menu button to access the settings for the above modes. See page
21 for more information on the Menu button.

Operating Modes

Filter Mode (page 19)
Vacuum Mode (page 18)
Feature 1 (page 34)
Feature 2 (page 34)
Note: If the pool system uses a filter, always monitor pressure at the filter when changing the speed (RPM)
or flow (m /h) from IntelliFlo.
3

Manual Mode

Metering the System

The first step in programming and operating the IntelliFlo is to determine the flow rates for the various
devices and features in your pool system that require flow. Because each pool system is unique, devices
that operate at a given flow rate in one system may not function optimally at that same flow rate in another
system.
IntelliFlo VF Installation and User's Guide
Operating IntelliFlo VF
®
FILTER 12:15
15.W
POWER
RUNNING
Section 3
Manual Mode (page 13)
Backwash Mode (page 17)
Menu Button
(to acces mode settings)
(page 21)