Units Menu; Priming Menu - Pentair IntelliFlo VF Manuel D'installation Et D'utilisation

24
Pool Data Menu (Continued)
d) To enter the water temperature:
scroll to the "Water Temperature" setting. Press the Select button to select
it. To change the setting, press the Left and Right arrows to select which
digit to modify, then use the Up and Down arrows to change the selected
digit. When you are done, press the Enter button to save the changes. To
cancel any changes, press the Escape button to exit edit mode without
saving.
Enter the current water temperature from 20°C - 40°C (Default 24°C).
Strict temperature accuracy is not critical since the water temperature
value is used only to enhance the accuracy of the flow sensor, however a
close estimate is desirable. Similarly, when the IntelliFlo is connected to
an IntelliTouch system, water and air temperature information is provided
by the system sensors. The more accurate the entered temperature, the more accurate the
flow reading will be on the IntelliFlo control panel LCD while it is running.

Units Menu

Use the Units menu to set the unit in which IntelliFlo will display data in the Control Panel. IntelliFlo allows
you to choose a unit for flow rate, time, and temperature.
To access the Units menu:
1. Ensure that the green power LED is on.
2. Press the Menu button. "Pool Data" is displayed.
3. Use the Up and Down arrow buttons to find the "Units" menu item. Press the Select button to select it.
a) To choose the Flow Unit:
setting. Press the Select button to select it. Use the Up and Down arrow buttons to choose between
cubic meters (m
b) To choose the Time Unit:
Press the Select button to select it. Use the Up and Down arrow buttons to choose between a 24-
hour time clock, or AM/PM, then press Enter to select the choice.
c) To choose the Temperature Unit:
"Temperature Unit" setting. Press the Select button to select it. Use the Up and Down arrow
buttons to choose between Celsius (°C), or Fahrenheit (°F), then press Enter to select the choice.

Priming Menu

To "prime" a pump means filling the pump and suction pipe with water. This process evacuates the air from
all the suction lines and the pump. It may take several minutes to prime depending on the depth of water,
pipe size and length. Water cannot fill the pipes to achieve prime unless the air first escapes, and it is easier to
prime a pump if the pool's piping system contains outlets for the air to escape. Pumps do not hold prime; the
pool's piping system has that task.
Priming is a function used every time the motor is started with a flow as reference. The "Priming Flow"
function ensures the proper operation of the pump. The "System Priming Time" function ensures proper
operation of the whole pool system.
IntelliFlo VF Installation and User's Guide
Use the Up and Down arrow buttons to
Use the Up and Down arrow buttons to scroll to the "Flow Unit"
/h), or gallons per minute (US GPM), then press Enter to select the choice.
3
Use the Up and Down arrow buttons to scroll to the "Time" setting.
Use the Up and Down arrow buttons to scroll to the
®
Pool Data 12:15
24 °C
Water Temperature