Ceiling Fan Assembly - Luminance Brands kathy ireland HOME ION ECO Mode D'emploi

3.1
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the Downrod (Figure 1) .
Remove the Pin from the 6" Downrod, then remove the
Hanger Ball (Figure 1) .
Retain the Pin and Hanger Ball for reinstallation in
Step 3 .8 .
NOTE: Do not loosen the Screw holding the Green
Ground Wire.
3.2
Separate, untwist and unkink the two 80" Motor Wires .
Route the 80" Black and White Motor Wires through the
6" Downrod (Figure 2) .
3.3
Loosen the two Phillips Head Set Screws in the Motor
Coupler for installation of the 6" Downrod (Figure 3) .
Seat the 6" Downrod in the Motor Coupler (Figure 3) .
Rotate and align the Downrod holes with all the holes in
the Motor Coupler (Figure 3) .

3. Ceiling Fan Assembly

PIN
PHILLIPS HEAD SET SCREW (LOOSENED)
Figure 1
TWO 80" MOTOR LEADS (UNTWISTED)
TWO 80" MOTOR WIRES (UNTWISTED)
Figure 2
LOOSEN
PHILLIPS HEAD
SET SCREWS (2)
Figure 3
Please contact 1-800-777-4440 for further assistance
5
GREEN GROUND WIRE
GREEN GROUND
WIRE SCREW
6" DOWNROD
HANGER BALL
6" DOWNROD
6" DOWNROD
MOTOR COUPLER
luminancebrands.com
U.L. Model No.: CF5300