Optional Installation Of No-Light Cover - Luminance Brands kathy ireland HOME ION ECO Mode D'emploi

7. Optional Installation of No-Light Cover

WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box or circuit breaker panel before
wiring. All wiring must be in accordance with National
and Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
IMPORTANT: Disconnection of the LED Light
Fixture Assembly Terminals from the Fan Motor
Housing Terminals prior to Assembly of the
No-Light Cover is necessary.
7.1
Remove and retain the Shade Assembly from the
opening of the LED Light Fixture Assembly by turning
the Shade Assembly counter-clockwise (Figure 26) .
NOTE: Store the Shade Assembly in a safe place for
future use, if needed.
7.2
Remove one of the #8-32 x 10mm Flat Head Screw
from the LED Light Fixture Assembly (Figure 27) .
Retain the #8-32 x 10mm Flat Head Screw for future
installation .
Loosen the two #8-32 x 10mm Flat Head Screws in the
key hole slots (Figure 27) .
Rotate the LED Light Fixture Assembly counter-
clockwise to disengage the Fixture from the two
loosened screws .
Carefully let the LED Light Fixture Assembly hang to
disengage the terminals .
LED LIGHT
FIXTURE
ASSEMBLY
DIMPLES
SHADE ASSEMBLY
ROTATE SHADE ASSEMBLY COUNTER-CLOCKWISE TO
DISENGAGE TO THE LED LIGHT FIXTURE ASSEMBLY DIMPLES
Figure 26
LED LIGHT FIXTURE LOOSEN TWO
ASSEMBLY #8-32 x 10mm FLAT
HEAD SCREWS
REMOVE ONE #8-32 x 10mm
FLAT HEAD SCREW
Figure 27
Please contact 1-800-777-4440 for further assistance
17
luminancebrands.com
U.L. Model No.: CF5300