Manual Operations - Irritrol Total Control Mode D'emploi

MANUAL OPERATIONS

Manual operation allows you to run individual stations or start automatic watering
programs as needed. The Total Control provides separate dial positions for each type of
operation: Single Station and Program Cycle.
Single Station
This option enables individual stations to be operated for an untimed duration (turned
On/Off) or operated for a selectable duration from one minute to 10 hours.
1. Turn the function dial to the
2. Select Program
NOTE:
The programmed status of the master valve/pump start in the selected program
determines whether the master valve/pump start will be activated with the manual
operation.
3. Use one of the following options to operate the station.
For untimed operation:
NEXT
a. Press the
ON
b. Press the
following occurs:
OFF
• The
• The controller clock passes midnight
• The function dial is moved to another position
For timed operation:
a. Press the
b. Use the
this operation only), from one minute to 10 hours.
c. To select additional stations to operate in sequence, repeat steps a and b as
desired. Each station will operate one-by-one in the order they were selected.
d. Leave the function dial in the
operation is complete, then return the dial to the
16
Single Station
A B C D
, , or with the Program switch.
button as necessary to display the station you wish to operate.
button. The station will turn on and remain on until one of the
button is pressed
NEXT
button as necessary to display a station you wish to operate.
+
–
and/or buttons to set the desired amount of station run time (for
position.
Single Station
position until the manual
RUN
position.