Irritrol Total Control Mode D'emploi page 19

PROGRAM CYCLE
Use this feature to manually operate watering programs. You can run the entire program or
start anywhere within the station sequence of the program.
NOTE:
Only the stations with an assigned run time in the program will operate during the
program watering cycle.
1. Turn the function dial to the
A B
2. Select Program , ,
NEXT
3. Press the button to select the fi rst station of the watering sequence (if other than
the station number displayed).
ON
4. Press the button to start the watering cycle. Watering will start with the selected
station and will be followed by all subsequent stations. The display will show the run
time remaining for the operating station.
NOTE:
You may advance through the stations by pressing the
station. To terminate operation at any time, press the OFF button.
5. Leave the function dial in the
complete, then return the dial to the
Program Cycle
C D
or with the Program switch.
Program Cycle
RUN
position.
NEXT
position until the manual operation is
position.
key for the next
17