Water Budget - Monthly Adjust; Program Stacking - Irritrol Total Control Mode D'emploi

% WATER BUDGET - MONTHLY ADJUST

The Monthly Adjust feature maximizes water conservation by allowing you to micro-adjust
watering on a monthly basis. By adjusting your irrigation during dry seasons, wet seasons, etc.,
you can be sure that your landscape areas are receiving the optimum irrigation while conserving
water resource.
NOTE:
It is possible to inadvertently cause start time stacking when increasing station run
time. Careful planning and use of % Monthly Adjust will prevent this from happening.
To change the Monthly Adjust percentage value of a selected program:
1. Turn the function dial to the
A B
2. Select Program , ,
NEXT
3. Press the button to select
+
–
4. Use the and/or buttons to increase or decrease the percentage value (0–200%).
NEXT
5. Press the button to adjust the percentage values for the remaining months.
4. Turn the function dial to the

PROGRAM STACKING

The Program Stacking feature enables you to select the number of programs which can
operate simultaneously. This allows you to match your water pressure and delivery rate
to your irrigation programs. By default, the four independent watering programs will
operate simultaneously if programmed to do so. This number is selectable from one to four
programs.
For example: The number of stacked programs is set to three. This limits operation to
three independent programs running simultaneously, whether the three the start times are
overlapping or the same. If the fourth program is set to start while three programs are
running, the fourth program will be delayed (stacked) until one of the currently running
programs has fi nished.
1. Turn the function dial to the
NEXT
2. Press the button to select Program Stacking. The number 4 (or previously set
number) will begin blinking to indicate the number of programs which can operate
simultaneously.
+
–
3. Use the and/or buttons to change the number from 1 to 4.
NEXT
4. Press the button to select the number.
5. Turn the function dial to the
% Water Budget
C D
or with the Program switch.
JA 100
(By default, January is set to 100%).
RUN
position.
% Water Budget
RUN
position.
position.
position.
15