Attendant Control Panel (Acp) - Arjohuntleigh ENTERPRISE E8000X Notice D'utilisation

Attendant Control Panel (ACP)

Attendant Control Panels are located on the outside panels of
both foot end side rails. The ACP on the left side and right side
of the bed have different button layouts.
can be mounted at the foot-end of the bed, either clipped onto the
foot board or using an ACP holder (ENT-ACC11) in an accessory
socket. The foot-end mounted ACP has the same button layout as
the right side rail mounted ACP.
Attendant Control Panel (patient's right hand side)
Power on indicator - lights when the bed is connected to the
electricity supply.
Battery indicator - refer to the section Backup battery on
page 38 .
These buttons raise and lower the mattress platform.
Mattress
platform height
When the mattress platform is lowered to 38cm* above the
floor, it will pause then continue to lower until it reaches its
minimum height.
(* 40cm on beds with 150mm castors.)
WARNING
At minimum height, clearance underneath the bed is reduced. Keep
your feet away from the areas below the side rails and take extra
care when using patient hoists or similar equipment.
These buttons raise and lower the backrest.
Backrest
The backrest will pause when it reaches an angle
approximately 30º above the horizontal.
34
Additionally, an ACP