During Use - Dräger FPS-COM 7000 Notice D'utilisation

Use
6. Press the push-to-talk button and check that the communication is
functioning.
When using the insert for the Bluetooth connection, wait until the
radio and the communication unit are connected to each other.
If no Bluetooth connection can be established, the insert must be
coupled again to the radio.
7. Switch off the radio and the communication unit.
3.3.2 Pairing the insert for the Bluetooth connection and the
radio
The insert for the Bluetooth connection must be fitted.
1. Set the radio to pairing mode.
2. Switch on the Bluetooth pairing mode of the communication unit:
Press the ON/OFF button
simultaneously.
The LED flashes blue when the communication unit and the radio
are being paired.
NOTICE
i
i
When using a Motorola APX radio, hold the blue dot over the
area on the communication unit indicated in Figure N on
page 7.
The device then indicates that it is ready for operation: the LED
lights up in green.
3. If necessary, select the Bluetooth name on the radio and, if
required, enter the activation code (0000).
In factory setting the Bluetooth name corresponds to the serial
number of the insert for the Bluetooth connection. It can be
modified using the optional configuration software.
When the radio and the communication unit were successfully paired,
it is possible to automatically connect both devices the next time they
are switched on. However, this depends on the type of radio which is
30
and the push-to-talk button
used and its configuration. The radio may require some settings to be
made.
3.4

During use

CAUTION
!
When using a communication unit with a radio, make sure that
there is no acoustic feedback from a second radio.
Acoustic feedback may cause hearing damage.
NOTICE
i i
If the Bluetooth connection is interrupted, the communication unit
will automatically attempt to establish this connection again until
the radio is within range again. The voice amplifier unit remains
functioning during this process.
3.4.1 Establishing readiness for use
1. Put on the full face mask. Position the earphone over the nomex
hood and below the protective helmet.
2. Switch on the radio and the communication unit.
3. Check the functioning of the communication unit: The volume of
spoken words must be amplified.
4. Adjust the volume on the radio if necessary.
5. Check that the communication via the radio is working.
3.4.2 Interrupting the automatic shutdown sequence
If the communication unit is not in active use, the "AUTO OFF" warning
signal sounds after approx. 4 minutes. If no further audio signals are
received by the communication unit, it switches itself off after another
minute has passed. It then needs to be switched back on again.
To interrupt the automatic shut-down, send an audio signal to the

communication unit (e.g. speak into the full face mask).
Dräger FPS-COM 7000