Dräger FPS-COM 7000 Notice D'utilisation page 33

Fault Cause
Insert cannot be fitted/ Screw blocks the
pulled out insert
Insert path blocked
Screw not completely
loosened
Communication unit Fixing lugs on mask
cannot be fitted/ visor frame not fitted/
dismantled faulty
Mount faulty
Fastening eyes on
communication unit
faulty
Communication unit
not hooked in
correctly
Earphone cannot be Earphone deformed
bent to desired or gooseneck faulty
position
Dräger FPS-COM 7000
Remedy Fault
Lift screw. No connection via
cable to radio
possible
Check sealing and
grease or replace as
necessary.
Clear insert path and
carefully fit insert.
Completely loosen
the screw, making
sure that the spring
below the screw can
move freely, lift it if
necessary.
Pressure switch jams Pressure switch
Replace visor frame.
Slide switch jams
Replace mount.
Replace fastening
eyes.
Dismantle
communication unit
and fit again.
Replace earphone.
Troubleshooting
Cause Remedy
Cable faulty Replace cable.
Cable not fitted Check connection
correctly between cable and
radio. Fit cable again
if necessary.
Check connection
between cable and
communication unit.
Fit cable again if
necessary.
Incorrect cable Use suitable cable.
connected
Clean pressure
soiled switch.
Slide switch soiled Dismantle and clean
slide switch.
Slide switch damaged Replace slide switch.
33