Adjusting The Volume; Preparations Before First Use - Dräger FPS-COM 7000 Notice D'utilisation

Use
3.1.6 Switching on the HazMat mode
1. Turn on the communication unit.
2. Keep the ON/OFF button pressed for approx. 8 seconds. Ignore
the shut-off signal when doing this.
An optical and an acoustic
communication unit is in HazMat mode.
The voice amplifier unit is switched off, the radio connection is still
working.
3.1.7

Adjusting the volume

NOTICE
i i
Press and hold down the volume controller for half a second
each time. Simply touching it does not change the setting.
To increase the volume, press the volume controller repeatedly

forward until the desired level is reached.
To reduce the volume, press the volume controller repeatedly

backward until the desired level is reached.
An acoustic signal indicates that the volume has been adjusted.
Another acoustic signal indicates that no further volume level is
available.
28
signal indicate when the
3.1.8 Selecting another group
NOTICE
i i
Press and hold down the group selector switch for half a
second each time. Simply touching it does not change the
setting.
Press the group selector switch repeatedly until the desired group

is selected.
The respective group is announced.
3.1.9 Configuring the communication unit
1. Fit the insert for the configuration cable.
2. Plug the configuration cable into a USB port on the PC.
3. Start the software on the PC.
An explanation how to operate the software is provided in the help
pages of the software.
3.2

Preparations before first use

1. Fit the suitable insert (see chap. 3.2.1 on page 29).
2. Insert the batteries (see chap. 5.3.1 on page 35).
3. Attach the communication unit to the full face mask (see
chap. 3.2.2 on page 29).
CAUTION
!
During assembly work the specified torques must be
observed since the communication unit could otherwise be
damaged. Use a suitable tool!
Dräger FPS-COM 7000