Skandika Fitness SF-2210 Mode D'emploi page 32

Step 3
Fix the backside of sliding beam set (60) onto main frame (1) with 2 Allen bolts (55) and 2 flat washers (66)
as shown in figure A. Fix the front side of sliding beam set (60) onto main frame (1) by 2 bolts (56), 2 spring
washers (11), 2 flat washers (66) and 2 domed nuts (12) as shown in figure B.
Assemble the rear cover (62) onto the front of main frame set as shown in figure C.
Connect middle handle pulse cable (47) and lower handle pulse cable (48) as shown in figure D.
Assemble the protective cover (75) onto the main frame as shown on figure E.
32