Low Standpipe Installation; Position And Level The Washer - Alliance Laundry Systems 202630CAR3 Mode D'emploi

Installation
1
4
1. Drain Hose
2. Cut Drain Hose off at This End to Fit the Washer Installa-
tion
3. Standpipe
4. Maximum Standpipe Height Not To Exceed 1.5 m [5 ft.]
Figure 7
IMPORTANT: Drain receptacle must be capable of han-
dling a minimum of 38 mm [1-1/2 inch] outside diame-
ter drain hose.

Low Standpipe Installation

If the drain facility is lower than the cabinet top, a siphon break
kit, Part No. 562P3, must be installed in the drain hose to prevent
siphoning action and drain hose MUST be cut to fit the washer
installation. Refer to Figure 8 . Use one No. 25863 Hose Cou-
pling to splice hose. The No. 562P3 Siphon Break Kit and No.
25863 Hose Coupling are available as optional equipment at ex-
tra cost through an authorized dealer or parts distributor. Installa-
tion instructions are supplied with the kit.
OPTIONAL: Raise the standpipe to the recommended height of
914 mm [36 inches].
IMPORTANT: Drain receptacle must be capable of han-
dling a minimum of 38 mm [1-1/2 inch] outside diame-
ter drain hose.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
2
3
TLW2210N_SVG
5
4
1. Drain Hose Elbow
2. 562P3 Siphon Break Kit
3. Standpipe
4. Cut Hose in This Area and Install No. 25863 Hose Cou-
pling
5. 25863 Hose Coupling

Position and Level the Washer

1. Position washer so it has sufficient clearance for installation
and servicing.
2. Place washer in position on a clean, dry, and reasonably firm
floor. Installing the washer on any type of carpeting is not rec-
ommended.
3. Place rubber cups (from accessories bag) on all four leveling
legs.
4. Place a level on the cabinet top and check if the washer is lev-
el from side to side and front to back.
5. If washer is not level, tilt washer back to access the front lev-
eling legs. Loosen the locknuts and adjust legs by screwing
into or out of washer base.
6. Once adjusted, tilt the washer forward on front legs and lower
back down into position to set the rear self-leveling legs.
7. Washer must not rock. When washer is level and does not
rock, tighten locknuts securely against bottom of washer base.
If these locknuts are not tight, washer will not remain station-
ary during operation.
Improper installation or flexing of weak floor will cause exces-
sive vibration.
Do not slide washer across floor once the leveling legs have been
extended, as legs and base could become damaged.
14
1
2
{
3
TLW2211N_SVG
Figure 8
Part No. 202630R3