Earth/Ground Instructions; Add Water To The Washer; Check Lid Switch; Check Installation - Alliance Laundry Systems 202630CAR3 Mode D'emploi

Installation
To reduce the risk of an electric shock or fire, DO
NOT use an extension cord or an adapter to connect
the washer to the electric power source.

Earth/Ground Instructions

This appliance must be properly connected to protective earth/
ground. In the event of malfunction or breakdown, the earth/
ground will reduce the risk of electric shock by providing a path
of least resistance for electric current.
The appliance is equipped with a cord having an equipment earth/
ground conductor and a three-prong earth/ground plug. The plug
must be plugged into an appropriate outlet that is properly instal-
led and connected to a protective earth/ground in accordance with
all local codes and ordinances.
Improper connection of the equipment earth/ground
conductor can result in a risk of electric shock.
Check with a qualified electrician or service person if
you are in doubt as to whether the unit is properly
connected to a protective earth/ground.
• DO NOT modify the plug provided with the unit – if it will
not fit the outlet, have a proper outlet installed by a qualified
electrician.
• If the laundry room's electrical supply does not meet the
above specifications and/or if you are not sure the laundry
room has an effective earth/ground, have a qualified electri-
cian or your local electrical utility company check it and cor-
rect any problems.
Any disassembly requiring the use of tools must be
performed by a suitably qualified service person.
This unit is equipped with a three-prong (earth/
ground) plug for your protection against shock haz-
ard and should be plugged directly into a protective
earth/ ground three-prong receptacle. Do not cut or
remove the earth/ground prong from this plug.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
WARNING
WARNING
WARNING
WARNING

Add Water to the Washer

To prevent damage to pump, do not run washer before adding at
least 0.95 liter [one quart] water to the tub. If the washer is run
before any water is added, the pump seal may overheat, causing
the pump to leak. Once installed, the water retained in the drain
system from the previous cycle will provide sufficient cooling to
W082
prevent pump seal damage.
NOTE: The agitator should not be removed except for
service. The washtub is designed to be self-cleaning.
W893

Check Lid Switch

Washer should stop filling, agitating and spinning when lid is
opened during a wash cycle.
W299

Check Installation

1. Refer to Installer Checklist on the back cover of this manual
W823 and make sure that washer is installed correctly.
16
TLW2056N_SVG
Figure 11
TLW2101N_SVG
Figure 12
Part No. 202630R3