Rapid Advance; Setting Dipswitch; Operation Instructions For Mdc Washers; Add Detergent - Alliance Laundry Systems 202630CAR3 Mode D'emploi

LED three times separated by a one and a half second pause until
the control is powered down. If Error Mode is turned off (refer to
Table 1 ), the drain error will not occur and the machine cycle
will advance to the next cycle step as though the water had been
pumped out.

Rapid Advance

The Rapid Advance feature allows the owner to quickly advance
into a cycle and advance an active cycle to a specific cycle step.
To enter Rapid Advance and advance through each cycle step,
open the meter case service door (on metered models) or the con-
trol hood (on nonmetered models), unplug the white bullet con-
nector with the black/white and gray/yellow wires on the hood
wire harness for at least one second, and then reconnect it. Each
time the connector is unplugged and reconnected, the control will
advance through the following steps:
• From Ready Mode, cycle will advance to wash (start of cy-
cle).
• From wash, cycle will advance to rinse following a short
pause. Wait for pause before advancing to next step.
• From rinse, cycle will advance to final spin following a short
pause. Wait for pause before advancing to next step.
• From final spin, cycle will advance to End of Cycle Mode.
• Open lid to clear End of Cycle Mode and return to Ready
Mode.

Setting Dipswitch

Cycle settings can be changed using the 8-Position dipswitch
mounted on the control. The control reads the dipswitch settings
at power-up. The control must be powered down to change the
dipswitch settings. The control is shipped from the factory with
all the switches in the OPEN position. Refer to Table 1 for dips-
witch settings.
Switch 1 is used to select whether a long or short cycle will be
used. Switch 2 is used to turn Error Mode on or off. Switches 3
through 8 are not used at this time.
Open (De-
Switch No. fault)
1 Long Cycle
2 Error Mode On
3-8 Not Used
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
Closed
Short Cycle
Error Mode Off
Table 1
Operation Instructions for MDC
Washers
IMPORTANT: Prior to first wash, use an all-purpose
cleaner, or a detergent and water solution, and a damp
cloth to remove shipping dust from inside of washer.
IMPORTANT: Remove all sharp objects from laundry to
avoid tears and rips to items during normal machine
operation.

Add Detergent

1. Pour measured amount of detergent into washtub. Refer to
package directions.
2. NEVER POUR UNDILUTED BLEACH DIRECTLY ON
LAUNDRY. Follow package directions when using bleach.

Load Laundry

1. Load dry clothes loosely into washtub – DO NOT overload!
(6.3 kg [14 lbs.] maximum dry clothes load)
2. When washing large items such as shag rugs and bedspreads,
add several small items to balance wash load.
23
W395I_SVG
Figure 28
Part No. 202630R3
Operation