CTC MID TIER Manuel De L'opérateur page 56

iii-5
56
Installation Instructions
Pneumatic installation
THE AIR INSTALLATION MUST BE PERFORMED
ONLY BY LICENSED PERSONNEL.
The machine requires an air pressure of 8 to 12 bar
(110-170 psi), as marked on the plate of the machine
and on a sticker attached to the cabinet next to the air
inlet.
Ensure that the line pressure is within the limits required
by the machine.
If the air pressure is lower than the minimum required
of 8 bar (110psi) the clamping power of the turntable
and the bead breaker power may be insufficient for
certain tIres.
It is suggested that the air supply be equipped with a
water separator to reduce the amount of water at the
air inlet.
BEFORE CONNECTING THE MACHINE TO THE AIR
SUPPLY BE SURE THAT NOTHING IS LEFT ON THE
TURNTABLE AREA (TOOLS,ETC).
After ensuring all the above proceed as follows:
• Connect the machine to the air supply (max.
pressure of 12 bar - 170 psi) with a rubber hose
(rated for the pressure) with an inside diameter of 6
mm (1/4") (Fig. iii-5).
• To install any accessory on request follow the
instructions enclosed with it.
• In case of installation of an air-filter and lubricator,
check correct functioning.
Operator's Manual MID TIER
Car Tire Changer