CTC MID TIER Manuel De L'opérateur page 54

54
Installation Instructions
iii Installation procedures.
Electric installation
THE INSTALLATION SHALL BE CARRIED OUT ONLY
BY QUALIFIED PERSONNEL AND WITHIN THE
SCOPE OF THE INSTRUCTIONS PROVIDED IN THIS
MANUAL.
Check on the plate of the machine that the electrical
specifications of the power source are the same as the
machine.
The machine uses 400 VAC, 50-60 Hz,
when equipped with a 3 phase motor and 230 VAC, 50-
60 Hz, 9 A when equipped with a 1 phase motor.
US and Canadian models require 115 VAC, 60Hz.
Electrical specifications are clearly marked on a label
at the end of the electric cable.
Before connecting the machine to the power source
check that the power supply has an efficient earthing
system.
Connect the electric cable of the machine with an
approved plug.
Note: The outlet installation must be verified by
a licensed electrician before connecting
the tire changer.
Note: The yellow/green wire in the cable is the
earth wire. Never connect the earth wire
to a live terminal.
Check that the power supply has an automatic circuit
breaker with a differential circuit rated at 30 mA.
The electric motor operates in a wide voltage range (plus
or minus 10%) and frequency range (50 or 60 Hz) and
has a class of insulation suitable for hot and moist
climates.
Operator's Manual
(EU 50Hz only)
MID TIER
Car Tire Changer