Franke CR 86 M Série Manuel D'installation Et Mode D'emploi page 17

CL 85 M / CM 85 M / CR 86 M _/F / SM 86 M _/F / SMP 86 M_/F
Removing the oven door (Fig. 4)
To facilitate oven cleaning, the oven door
can be removed by operating on the hinges
as follows:
X X
The hinges are equipped with two
moveable locks (A). Lift the lock (A)
to release the hinge.
X X
Then lift the door up and pull it outwards;
to do this, hold the door at the sides near
the hinges.
X X
To refit the door, first slide the hinges into
their grooves.
X X
Before closing the door, remember
to turn the two locks (A) used as hinge
attachments.
Refer to the pictures at the end of this manual.
Removing the side frames
X X
Bend the crosspiece engaged in the fixing
bush downwards and remove it from
the groove.
X X
Tilt the frame upwards by approx. 60°
and push it slightly in the direction
of inclination.
X X
Keeping the frame tilted, remove the two
top hooks from the respective holes.
1
Fitting the side frames
X X
Keeping the frame tilted, insert the top
hooks in the respective holes, pushing
lightly in the direction of inclination.
X X
With the frame tilted, pull in the direction
of inclination until the top hooks stop
against the outside of the compartment
wall.
X X
Turn the frame towards the compartment
wall. Bend the crosspiece engaged
in the fixing bush downwards and remove
it from the groove.
Replacing the oven lamp
A
X X
Turn off the power to the appliance
by means of the omnipolar switch used
for connecting it to the electrical system,
or disconnect the plug if accessible.
X X
Unscrew the glass cover (A).
X X
Unscrew the lamp and replace it with one
resistant to high temperatures (300 °C),
with the following characteristics:
– Voltage: 220/240 V ~ 50-60 Hz
– Power: 25 W
– Connection: G9
X X
Refit the glass cover (A) and reconnect
the power supply.
CAUTION! Damage to the lamp due to wrong
handling!
Z X
Avoid touching the lamps with bare hands.
Z X
Use a cloth or a sheet of kitchen paper.
3
shock!
Z X
Ensure that the oven is switched off before
replacing the lamp.
2
due to wrong handling!
Z X
Switch the oven off.
–
– 17 –
Franke ovens are
equipped with
a circular lamp
positioned in the top
left area at the back
of the compartment.
To replace the oven
lamp, proceed
as follows:
WARNING! Possibility of electric
W
ARNING! Electric shock
Depending on how the oven
is installed: Unplug the oven
or disconnect the power at the main
electrical system switch, e.g., switch
off the fuse of the oven in the fuse box.
EN