Bartscher C5230 Mode D'emploi page 53

o If the device has wheels make sure that electrical wires, tubes or other attachments are
not damaged in the process.
o Avoid placing the unit near heat sources (such as fryers, etc.).
o After the operation and position the device in its place of normal installation, and make
sure that all the electrical and water connections are made in accordance with the
standards before starting the unit.
Troubleshooting
In the event of a fault, disconnect the device from the power supply and close the water
supply. Before contacting the customer service department check the nature of
malfunction described in the table below.
Fault
The convection
oven will not start
when turned on
The convection
oven is completely
turned off
The light is turned
off
The food
cooks/bakes
unevenly
Reason
 The oven door is not
closed.
 The microchip does not
signal the oven door is
closed.
 No power supply.
 The power supply
connection has not been
made properly.
 Motor protection thermostat
kicked in
 The lamp got loose.
 The lamp is blown.
 Fans do not change the
direction of rotation.
 One of the fans is not
working.
 One of the resistors is
broken.
Solution
 Close the oven door.
 Contact the Customer
Service.
 Restore power supply.
 Check the power
connection.
 Contact the Customer
Service.
 Place the lamp in the holder
correctly.
 Replace the lamp as
described in the section
"Replacing the lamp"
(6.2 "Cleaning").
 Contact the Customer
Service.
 Contact the Customer
Service.
 Contact the Customer
Service.
49