Bartscher C5230 Mode D'emploi page 45


Make sure the power cord does not get damaged when moving the oven. This way
the oven will be connected to the power supply without difficulty and in a more safety
manner. The power cord shall be placed so that it does not reach the ambient
temperature higher than 50°C at no point.
Convection oven with a single-phase power cord and plug (206873)

For units equipped with a cord and plug (single phase, 230 V), simply insert the
plug into the appropriate socket (the socket must match the provided plug and
withstand the load required for the oven and specified on the nameplate).The device
must be positioned so that the plug is easily accessible at all times.

The oven is supplied with a certified cord and plug: do not tamper them or change
anything in them.
Convection oven with a three-phase power cord and no plug (206782, 206797)

CAUTION: in the connecting power cord, the yellow/green wire should be at
least 3 cm longer than the other wires.

The convection oven should be connected directly to the power grid and provided
with a previously connected and easily accessible switch installed in accordance
with the applicable international, national and local regulations. This switch should
have a contact opening for all poles in order to ensure a complete shutdown in case
of over-voltage of category III

It is essential to properly connect the earth wire which cannot be disconnected under
any circumstances by the protective switch.

Make sure, before connecting the oven to the power grid, that all the power cords
are securely connected.

Also take into account connections prepared for individual devices; they can be
found on the back of the oven
Yellow/green: The protective wire "EARTH".
Blue: Neutral wire
Brown, gray, black: live wires
41