Set Up Requirements; What's In The Box; What You Need - Angelcare AC027 Manuel De L'utilisateur

• Be sure replacement parts are supplied by Angelcare
and have the same characteristics as original part.
Unauthorised substitution may result in fire, electric
shock or fire.
36. Nursery Unit Antenna - The antenna used
for this transmitter must be installed to provide a
separation distance of at least 8'' (20 cm) from all

SET UP REQUIREMENTS

WHAT'S IN THE BOX

Nursery Unit
1
2 x 1.5V AAA batteries (for Nursery Unit)
2
Stand (for Nursery Unit)
3
Sensor Pad
4
CR2450 3V Battery
5
(for Sensor Pad)

WHAT YOU NEED

• Hardboard, if the crib does not
have a firm surface
(see 'IMPORTANT' note - Step 1)
• Posidrive screwdriver
1- SETTING UP THE SENSOR PAD
The Sensor Pad is designed to detect subtle baby movements on the surface of the
mattress.The alarm will only sound if NO movement is detected for 20 seconds.
3
4
1
2
Correct positioning
for slatted base
persons and must not be collocated or operating in
conjunction with any other antenna or transmitter.
37. Cleaning - Disconnect all units before cleaning.
DO NOT immerse any part of the monitor in water.
Clean only with a dry cloth.
1
4
1. Use a coin to remove/replace the
battery cover and insert the battery
face with + face up.
2. Replace the battery cover, align 2
dots and click to secure.
3. Remove the mattress from
the cot, place Sensor Pad
- Angelcare® logo side up - on
base in approximate centre of
mattress, along the length. It should
be centred on the hardboard if your
cot requires a hardboard support
(see 'IMPORTANT' note below).
4. Replace the mattress.
3
2
2x
5