Setup Requirements - Angelcare AC417 Manuel De L'utilisateur

after you have removed your baby from the cot. Another reason is
the Sensor Pad has not been placed under the mattress properly.
Be sure the Sensor Pad is on a flat, firm surface with the Angelcare
side facing up. The sensitivity level may also need to be adjusted. Refer
to Step 5.1. Always be sure to immediately check on baby whenever an
alarm sounds.
12.20 Sensor Pad ‑ Your Sensor Pad can be used in any cot that is stationary.
If the cot has a spring or slat base, place a hard board between the cot base
and the Sensor Pad measuring at least 33 x 33 cm and 6 mm thick. Only
use your Angelcare monitor in a stationary sleeping environment such
®
as a cot where the Sensor Pad can rest on a completely flat, firm surface.
The Sensor Pad is made of plastic and does not permit the air to circulate.
Therefore, mildew build up could develop underneath the mattress in the Sensor
Pad area. We suggest rotating the mattress regularly to prevent any mildew.
13. IMPORTANT SAFETY INSTRUCTIONS RELATED TO USE OF BATTERIES
13.1 Use ONLY the type and size of battery specified in the owner's manual.
There is a risk of explosion if battery is replaced with an incorrect type.
13.2 Charge the battery for 9 hours prior to first use. Be sure to have the
monitor in the OFF position during this period. ONLY use the adapters
included with your monitor.
13.3 DO NOT use these adapters with any other equipment.

SETUP REQUIREMENTS

INCLUDED:
Touchscreen Parent Unit
Wireless movement
Sensor Pad
* Always place
Angelcare logo side up *
13.4 When unplugging the adapter from the Camera, be sure it is switched
to the OFF position.
logo
®
13.5 DO NOT dispose of batteries in fire. They may explode. Check with
local regulations for possible special disposal instructions.
13.6 Exercise care in handling batteries in order not to short out the
batteries with conducting materials such as rings, bracelets and keys.
Overcharging, short circuiting, reverse charging, mutilation, or incineration
of batteries must be avoided to prevent one or more of the following
occurrences: release of toxic materials, release of hydrogen and/or oxygen,
gas and rise in surface temperature.
13.7 DO NOT attempt to rejuvenate the battery provided with or identified
for use with this product by heating them. Sudden release of battery
electrolyte may occur, causing burns or irritation to eyes or skin.
13.8 If and when necessary, the battery must be replaced with identical
new ones or equivalent (volts and size).
13.9 Remove the battery from the Parent Unit if you store the product
over 30 days because the battery could leak and damage the product.
13.10 Discard 'dead' batteries as soon as possible since 'dead' batteries
are more likely to leak in a product. If a battery has leaked or vented, it
should be replaced immediately using protective gloves.
13.11 DO NOT store this product, or the battery provided with or identified
for use with this product, in high‑temperature areas.
Tabletop stand with
Camera
2 x AC adapter
(for Parent Unit and
Camera)
CR3032 battery
(for Sensor Pad)
Model AC417 and AC517
Baby Video, Sound and
Wireless Movement Monitor
removable wall
mount metal ball
(for Camera)
Lithium ion battery pack
(for Parent Unit)
Hardware
(Screwdriver
required
for wall mounting)
63
E
N