GETINGE Arjohuntleigh RIK Fluid Overlay Mode D'emploi page 6

Assembly of the RIK Fluid Overlay (continued)
4. Repeat the previous procedure with each blue bottom end pad so that all three
pads are attached to the bottom panel (Figure 3). Ensure that the blue bottom
end pads sit snugly against the black bottom center pad. Fold the wing at the
HEAD end of the bottom panel upward, and tightly fasten the nylon hook and
loop straps on each side to the adjacent side wings (Figure 3 magnified view).
Figure 3
5. Zip top cover onto bottom panel ensuring HEAD and FOOT ends are properly
aligned (Figure 4). Note the seven magnet flaps must detach from the wings
so that the top cover zips between each flap and wing.
Figure 4
Magnified view of corner
6