Activate Automatic Transmission (Asend) - Seca 954 Mode D'emploi

Activate automatic
transmission (ASend)
NOTE:
With certain devices a special switch-on proce-
dure has to be followed if they are to be inte-
grated in a wireless group. Consult the user
manual for each device.
11. Switch on the equipment device you wish to inte-
grate in the wireless group, e.g. wireless printer.
A beep will be heard when the wireless printer is
detected.
NOTE:
As soon as you have integrated a wireless
printer in the wireless group, you have to select
a print option (menu\rf\APrt) and set the time
(menu\rf\time).
12. Repeat step 11. for all equipment devices you wish
to integrate in the wireless group.
13. Press the Enter key to end the search.
14. Press one of the arrow keys to see which devices
have been detected (here: Mo 3 for a wireless
printer).
Once you have integrated several devices in the
wireless group, press the arrow keys several times
to check that all equipment has been detected by
the scales.
15. Press the Enter key to leave the menu or wait until
you leave the menu automatically.
You can configure the scale so that the measurement
results are automatically sent to all receive-ready recip-
ients signed into the same wireless group (e.g.: wire-
less printer, PC with USB wireless module).
NOTE:
If you are using a wireless printer, ensure that
"off" is not set as a print option (see "Select
print option (APrt)" on page 78).
1. Switch the device on.
2. Select the menu item "ASend" in the "rf" submenu
and confirm your selection.
3. Select "on" and confirm your selection.
You will leave the menu automatically.
seca 360° wireless Network • 77
English