Activate Automatic Transmission (Asend); Select Print Option (Aprt) - Seca 704 Mode D'emploi

Activate automatic
transmission (ASEnd)
Select print
option (APrt)
14. Press one of the arrow keys to see which devices
have been detected (here: "MO 3" for a wireless
printer).
Once you have integrated several devices in the
wireless group, press the arrow keys several times
to check that all equipment has been detected by
the scales.
15. Press the Enter key to leave the menu or wait until
you leave the menu automatically.
16. If you do not wish to make any more settings, press
the Start key.
The settings will be saved.
The device switches off.
You can configure the device so that the measured
results are automatically transmitted to all receivers that
are ready to receive and logged into the same wireless
group (e.g.: wireless printer, PC with USB wireless
module).
NOTE:
If you are using a wireless printer, ensure that
"Off" is not set as a print option (see "Select
print option (APrt)" on page 61).
1. Switch the device on.
2. Select the menu item "ASEnd" in the "rF" submenu
and confirm your selection.
3. Select "On" and confirm your selection.
You will leave the menu automatically.
4. If you do not wish to make any more settings, press
the Start key.
The settings will be saved.
The device switches off.
You can configure the device so that measured results
are automatically printed out by a wireless printer
logged into the wireless group.
NOTE:
This function is only available if the "Learn" func-
tion has been used to integrate a seca wireless
printer in the wireless group.
1. Switch the device on.
2. Select the menu item "APrt" in the "rF" submenu
and confirm your selection.
seca 360° wireless Network • 61
English