Transportation And Storage - Güde GWS 400 HM-2 Traduction Du Mode D'emploi D'origine

Scies à bascule

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Check all screw and plug-in connections and

protective equipment if firm and tightened properly

and whether all moving parts are running smooth

whenever the appliance is to be put into operation.

Ensure that the separating safety equipment

and other safety equipment which is necessary for

operating the machine is fitted, is in a good

operating condition and is properly serviced.

The protective equipment on the appliance is

strictly prohibited to be disassembled, changed,

used in conflict with the designation and it is

prohibited to attach any protective equipment of

other manufacturers.

For cleaning and maintenance, the following safety

guards must be removed: Additional safety device

for saw blade protection

After carrying out the work, all safety guards must

be reinstalled again correctly! See image

description.

The machine must not be used under any

circumstances if the machine or the safety devices

are damaged. Replace any worn and damaged

parts.

The blade is very hot after use, wear gloves or

allow to cool before maintenance or cleaning

procedures.

Before use check appliance, cable, extension cord and

plug for any damages or material fatigue.

The operating personnel must have received

sufficient training in use, setup and maintenance.

Errors in the machine, including the guard or the

blade shafts, must be reported to the person

responsible for safety as soon as they are discovered.

Before pressing On/Off, make sure the saw blade has

been fitted properly.

The saw must not be used any longer if the cradle fails

to automatically return to the rest position.

The saw must not be used any longer if the saw blade

fails to stop in 10 seconds after switching the machine

off.

For security, use devices such as safety- and pressure

device, guide slide, rip fence, etc.

Removing sawdust and chippings from the machine

when running is strictly prohibited.

It is necessary to refrain from removing any cuttings

and parts of workpieces from the cutting area.

Do not use saw blades which are damaged or

deformed

Properly sharpened saw blades to be used only.

Observe the maximum speed indicated on the saw

blades.

Follow instructions for use, adjustment and repair of

saw blades of manufacturers.

Do not use saw blades not corresponding to the key

data given in these instructions for use.

The rated speed of the accessory must be at least

equal to the maximum speed marked on the power

tool.

Only use tools that meet standard EN 847-1.

Transport and store the tools in a suitable receptacle;

To minimise noise production, the tool must be

sharpened and all elements for noise minimisation

(covers, etc.) must be properly adjusted.

Replace the table insert when worn

Familiarise with the safety procedures for cleaning,

maintenance and regular removal of sawdust and

dust to reduce the risk of fire.

Make sure the flange used is suitable for the given

purpose of use, as specified by the manufacturer.

Use only original accessories and original spare parts.

Installation and larger-scale repair work may only be

carried out by personnel who have received special

training.

Keep the Log Cutting Saw, the mains plug and the

power cable away from open flames and hot surfaces.

Switch the machine immediately off when blocked.

Unplug the machine and remove the stuck piece of

wood.

Ensure the working space has sufficient general or

targeted lighting.

Ensure that the separating safety equipment and

other safety equipment which is necessary for

operating the machine is fitted, is in a good operating

condition and is properly serviced.

The operating personnel must have received suffi-

cient training in use, setup and maintenance.

Notices relating to restrictions on use in places where

the fire risk may be high.