Güde GWS 400 HM-2 Traduction Du Mode D'emploi D'origine page 35

Failure removal
FAILURES
Not working when pressing the
on-off switch.
Device is not running at full speed
or unusual sounds from motor.
The saw blade brake does not bring
the saw blade to a standstill within
10 seconds.
POSSIBLE CAUSES
No electricity
On-off switch defective
Motor is overheating
Motor defective
There may be a defective fuse in
the switch.
ENGLISH
RECOMMENDED SOLUTION
Check the electricity supply
Have on-off switch replaced by an
approved after-sales service team.
Turn off device and leave to cool
for 30 minutes.
Have on-off switch replaced by an
approved after-sales service team.
Consult a qualified electrician or
inform the Güde service team.
31