Replacement Of Grinding Disc; Field Of Application; Technical Specifications; Training - Migatronic GREEN POINTER PRO Mode D'emploi

9. Replacement of grinding disc

Please follow the procedure below when
disassembling the machine:
1. The power to the Green Pointer Pro must be
turned off – pull out the plug.
2. Tap of the grinding liquid
3. Remove the two screws, the cover frame and the
plastic inspection cover
4. Set the grinding angle to 90º. The disc is now
assessable
5. Unlock the center screw (Note: Left-hand screw)
6. Remove the retaining disc and the grinding disc
and mount a new grinding disc

10. Field of application

Only use the grinder for grinding of tungsten
electrodes.

11. Technical specifications

The Green Pointer Pro is covered by Tungsten grinder
patent application No. 95942059.7.
Current class: (single-phase alternating current)
1x110V or 1x220-240V AC. Depending on the model.
Please see the nameplate on the grinder for the
power supply.
Safety protected with protective earth. According to
directive 2014/35/EU.

12. Training

No special education is required to operate the Green
Pointer Pro. However, persons who are to operate
the machine should read the instruction manual
thoroughly beforehand and to have received basic
training in use of the machine.

13. Safety data sheet for grinding fluid

For more information about the grinding liquid,
please contact Migatronic A/S.
13