Maintenance / Locations Of Errors / Warranty; Warranty Regulations - Migatronic PILOT 1500 HP Manuel D'instruction

MAINTENANCE
The PILOT welding machines require virtually no
maintenance. However, exposure to extremely dusty,
damp or corrosive air is damaging to welding
machines.
In order to prevent problems arising, the following
procedure should be observed at least once a year.
- open the machine and clean it with clean, dry,
compressed air
Lack of maintenance can lead to reduced reliability
and repeal of the guarantee.
LOCATIONS OF ERRORS
Attempts to locate errors should only be made by
trained experts.
The machine does not work and/or the display does
not light:
Check that mains fuse has not been damaged and
that mains supply is switched on. Replace fuse and/or
switch on supply if necessary.
Mains error:
Occurs if there is too low or too high voltage on the
supply mains.
Ensure that mains fuse and supply are as specified.
Overheat:
Occurs if the machine is overloaded. This occurs
when welding with higher load than permitted, or if the
machine needs cleaning.
Ensure machine data or clean modules with clean,
dry, compressed air through the cooling ducts.

WARRANTY REGULATIONS

All MIGATRONIC machines carry a twelve month
guarantee against hidden defects. Such defects
must be notified no later than two months after it has
been noticed. The warranty runs for twelve months
after invoicing to end customer.
The warranty becomes void by faults that can be
attributed to incorrect installation, pests, transport
damage, water- and fire damage, strokes of
lightning, use in connection with a synchronous
generator and use under abnormal conditions, which
lies beyond the product specification.
Lack of maintenance
There is a lapse of warranty if the product is not
properly maintained e.g. if the product is dirty to such
a degree that cooling is hindered. The warranty does
not cover damages which can be traced back to
unauthorised and incorrect repairs of the product.
Wear parts
The warranty does not cover wear parts (welding
hoses, welding cables and wire drive rolls)
Resulting damages
Use of the product must stop immediately after
acknowledgement of a defect in order to avoid
further damage of the product. The warranty does
not cover resulting damages due to use of the
product after acknowledgement of a defect. More-
over, the warranty does not cover resulting damages
on other items due to product defect.
14