Introduction; Also Observe The Following Technical Documents; Safety; Authorized Staff - Bitzer LHL3E/2EES-2Y Instructions De Service

1 Introduction

These condensing units are intended for incorporation
into refrigeration systems in accordance with the EU
Machinery Directive 2006/42/EC. They may only be put
into operation if they have been installed into the refri-
geration systems according to these mounting/operat-
ing instructions and if the overall system complies with
the applicable legal provisions.
The condensing units have been built in accordance
with state-of-the-art methods and the applicable regula-
tions. Particular importance has been placed on user

safety.

The electrical components correspond to the EU Low
Voltage Directive 2014/35/EU. Moreover, the pressur-
ised components must comply with the EU Pressure
Equipment Directives 2014/68/EU (PED) (see table 1,
page 45).
These operating instructions must be kept available
near the refrigeration system during the whole lifetime
of the condensing unit.
1.1 Also observe the following technical
documents
In addition to these instructions, the operating instruc-
tions and Technical Information for the respective com-
pressors and pressure vessels must be taken into ac-
count.
• ECOLITE Quick Guide
• KB-104 operating instructions BITZER ECOLINE
• DB-300 pressure vessel: Liquid receivers and oil
separators
• KT-101 CR II system / capacity control for
BITZER ECOLINE
• The manufacturer's documentation of the individual
components included in the scope of delivery
KB-206-2
2 Safety

2.1 Authorized staff

All work done on compressors and refrigeration sys-
tems may only be performed by qualified and author-
ized staff who have been trained and instructed accord-
ingly. The qualification and expert knowledge of the
personnel must correspond to the local regulations and
guidelines.

2.2 Residual risks

The individual components of the condensing unit may
present unavoidable residual risks. That is why any
person working on this device must carefully read these
operating instructions!
The following regulations shall apply:
• the relevant safety regulations and standards (e.g.
EN378, EN60204 and EN60335),
• the generally accepted safety rules,
• the EU directives,
• national regulations.

2.3 Safety references

are instructions intended to prevent hazards. Safety ref-
erences must be stringently observed!
NOTICE
!
!
Safety reference to avoid situations which may
result in damage to a device or its equipment.
CAUTION
Safety reference to avoid a potentially hazard-
ous situation which may result in minor or mod-
erate injury.
WARNING
Safety reference to avoid a potentially hazard-
ous situation which could result in death or seri-
ous injury.
DANGER
Safety reference to avoid an imminently hazard-
ous situation which may result in death or seri-
ous injury.
43