The Standard Mode - 2T - Expert allows to access the
Chart (Pre-gas, HotStart, Crater Filler and Post-gas)
The Standard Mode - Spot - Expert allows to access the
chart (Pre-gas and Post-gas).
4/ Pulse mode
In pulse mode – use the left side for the main settings
and the right side for arc length settings.
The Expert and Advanced modes give access to the
welding cycle.
30
AUTOPULSE 320-T3
The Standard mode - 4T - Expert allows to access the
Chart (Pre-gas, HotStart, Crater Filler and Post-gas) -
With this mode, these parameters can be managed by
the trigger, see welding cycle.
Standard Mode - 2T - Advanced allows to access arc
lengths.
Use the simple mode second window to set the welding
position and the self.
In 4T mode, the Hotstart, pre gas, crater filler and post
gas can be controlled through the trigger.
EN