Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
Rotation of the left control knob.
2
Rotation of the right control knob.
Welding position.
Flat position
Angle position
Trigger mode (2T, 4T, Spot, Delay).
Wire diameter.
Couple: Material-Gas.
Setting the thickness to be welded.
Setting the electronic induction.
Setting the arc length.
Chart mode (level, duration, arc length).
OVERVIEW OF INTERFACE LEVELS
1/ Menu and settings
28
AUTOPULSE 320-T3
This section allows to set the welding mode (Manual, Standard, Pulsed or Pulse In
Pulse)
In Standard mode, pulsed and pulse in pulse mode, it is possible to select the trigger
mode, wire diameter and the couple material-gas.
This menu allows to choose the main parameter in box mode (thickness of the part to
be welded, wire speed, average welding current).
EN
Publicité
Table des Matières
