Pulse Mode - GYS AUTOPULSE 220-M3 Mode D'emploi

In Standard Mode - Delay - The left control knob allows
to adjust the duration of the point and the right knob
the delay between each point
The Standard Mode - 2T - Expert allows to access the
Chart (Pre-gas, HotStart, Crater Filler and Post-gas)
The Standard Mode - Spot - Expert allows to access the
chart (Pre-gas and Post-gas).

4/ Pulse mode

In pulse mode – use the left side for the main settings
and the right side for arc length settings.
30
AUTOPULSE 220-M3
The Standard Mode - 2T - Expert allows to access the
Chart (Pre-gas, HotStart, Crater Filler and Post-gas)
The Standard mode - 4T - Expert allows to access the
Chart (Pre-gas, HotStart, Crater Filler and Post-gas) -
With this mode, these parameters can be managed by
the trigger, see welding cycle.
Standard Mode - 2T - Advanced allows to access arc
lengths.
Use the simple mode second window to set the welding
position and the self.
EN