GYS AUTOPULSE 320-T3 Mode D'emploi page 31

The advanced mode is used to set the arc voltage at
each welding cycle.
5/ Pulse In Pulse mode
In Pulse in Pulse mode, the left window allows to
access the main parameter and the right one to the arc
length.
Expert mode and advanced mode allow to access the
welding cycle.
The advanced mode allows to access the arc voltage of
each phase of the welding cycle.
AUTOPULSE 320-T3
The second window of the simple mode allows to access
the welding position and to the self.
In 4T mode, the Hotstart, pre-gas, crater filler and post-
gas can be managed by the trigger.
EN
31