Important - Beper 70.254 Manuel D'instructions

Ice Cream Maker Use instructions

Important

■ Do not stop and start the machine during the freezing process, as the mixture may freeze in
contact with the bowl and prevent movement of the paddle.
■ In the unlikely event of the motor overheating, a safety cut out will operate causing the motor to
stop. If this happens, switch off, unplug the machine and allow the power unit to cool.
■ For the best result of ice cream, the paddle will contact with the inside of the inner tank when
the paddle moves.
12 When the ice cream is completed, put a cup under the outlet pedestal unit and push the outlet
lever down, the outlet pedestal unit is opened and the ice cream is squeezed out.
■ In order to squeeze out the ice cream, the motor must be running. If the safety cut out operates
and the motor is stopped, switch off and remove the power unit/lid. Remove the ice cream from the
inner bowl by a rubber spatula or wooden spoon.
■ The ice cream produced should be a soft spoonable type. This can be transferred to a separate
container for storage in the freezer or if you wish to firm the ice cream before eating.
Important
■ Do not use metal utensils to remove ice cream from the inner tank.
■ Do not remove the inner tank from the freezer until ready to make ice cream.
Hints
■ We suggest that you keep the inner tank in the freezer so that it is ready for use. Place in a
plastic bag before freezing. Freeze the inner tank in the upright position.
■ Always make sure the inner tank is thoroughly dry before placing in the freezer.
■ Do not puncture or heat the inner tank.
■ The inner tank should be placed in a freezer that is operating at a temperature of -18° Centigra-
de ( -0.40° Fahrenheit) or below for at least 8 hours before use.
■ For best results always refrigerate the ingredients before making ice cream.
■ The addition of alcohol to recipes inhibits the freezing process.
Cleaning
■ Always switch off, unplug and dismantle before cleaning.
■ Never put the power unit in water or let the cord or plug get wet.
■ Do not wash parts in the dishwasher.
■ Do not clean with scouring powders, steel wool pads, or other abrasive materials.
Power unit
■ Take out the power unit from the lid.
■ Wipe with a damp cloth, then dry.
Lid
■ Wash the lid then dry thoroughly.
Paddle
■ Take out the paddle from the inner tank.
■ Hold up the upper axle, lift up the ring and take out the lower axle from the buckle of the upper
axle. Then turn the middle axle anticlockwise, dismantle the lower axle from the paddle.
■ Wash then dry thoroughly.
19