Publicité
Les langues disponibles
Les langues disponibles
any contact of your body with the current. Your
machine has a cable with a grounding conductor and a
grounding plug. The plug should be connected to a
specifically designed connection installed and grounded
in compliance with local standards and provisions.
•
Any alterations on the plug not complying with the
connection should be done by an electrician. The same
applies to the connection installation.
•
If the grounding conductor installation is not correct, an
electrical shock hazard is imminent. Grounding
conductor is a green or green/yellow striped cable. Use
only manufacturer-delivered power cables with
compressed connection with the safety switch.
•
(M type connection, see No. 222 in the list of spares). If
it is necessary to replace power cable of your machine,
never use the grounding conductor as a power cable.
•
Should you have any queries regarding the grounding
connection and should you be uncertain about proper
grounding of your machine, consult an electrician.
•
Use only three-wire extension cables and three-pole
sockets matching the plug of your machine.
•
Any defective or worn power cables should be repaired
or replaced immediately.
Maintenance and care
•
Always unplug the machine prior to the disk or brushes
replacement, lubrication with oil or other pre-
maintenance operations
•
Never set the bevel angle or do other modifications with
the motor running.
•
It is necessary to make sure after any use whether or
not the machine is still in full working condition. To
check the carbon brushes, the brushes lid needs to be
removed using a screwdriver. The brushes need
replacement if wear-and-tear has reached above the
mark (6mm) or if small particles have split off (Fig.
7+8)
After the use:
•
Loosen the screw, pull the cuts-collecting box out.
Empty the box, put it back in the opening and tighten
the screw again (Fig.9)
Machine Lubrication with Oil
•
Once in a month, the machine has to lubricated with oil
on the spots shown below. It will make service life of
your machine longer.
- Spindle rotating part
- Hand wheel rotating part
- Clamp sliding surface area
Disk Replacement:
Pic. 10 and 11:
A: Spindle
B: Locking knob (on the handle)
C: Retaining ring
D: Hexagon screw
E: Seeger ring
F: Washer
G: Flange
H: Disk
•
Before replacing the disk, unplug the machine. Loosen
the wing-nut (Fig. 11) and remove the cover. Lock the
spindle (10/A), (Fig. 11) using locking knob (B, Fig. 4)
•
Loosen the disk screw (10/D) using an inner-hexagon
wrench
•
Remove the disk (10/H) with care - (CAUTION: wear
safety gloves)
•
Slide the flange (10/G) on the spindle
•
Install the disk and make sure that the teeth point to the
solid stop.
•
Install the retaining ring (10/C), flange (10/G), washer
(10/F), Seeger ring (10/E) and hexagon screw (10/D)
•
Lock the spindle (10/A) with the lock knob (4/B) and
tighten the disk screw as required.
•
Before you plug the machine, remove the retaining rod
and forked wrench and fit the cover in place!!! (Fig. 10+
11)
11
Publicité
