Function Modules (Optional); Mounting - Lenze Global Drive 8200 vector Instructions De Montage

Show/Hide Bookmarks

Function modules (optional)

Mounting

6 Function modules (optional)
Danger!
•
The pins of the FIF interface have a basic isolation (single-insulating distance).
•
Protection against contact in the event of a defective insulating distance can only be ensured
by external measures (e.g. double insulation).
Which function modules can be used?
8200 vector with a function module o
8200 vector with two function modules o
6.1 Mounting
Function module on interface FIF I
1. Disconnect the controller from the mains and wait for at least 3 minutes!
2. Remove and keep blind cover
3. Remove and keep the FIF protection cover
2
4. Plug the function module on the interface FIF I.
5. Press against the function module until it is snapped into place.
6. Assign the terminals of the function modules (PES: HF- shield connection by
connecting the shield to PE)
32
o o Possible function modules on FIF I o
o o o Possible function modules on FIF I o
Possible function modules on FIF II o
0
.
1
.
EDK82EV903 DE/EN/FR 1.0
o o o
Standard I/O
Standard I/O PT
Application I/O
INTERBUS
PROFIBUS-DP
LECOM-B (RS485)
System bus (CAN)
o o o
INTERBUS
PROFIBUS-DP
LECOM-B (RS485)
System bus (CAN)
o o o
Standard I/O
Standard I/O PT
Function module on interface FIF II
1. Disconnect the controller from the mains and wait for at least 3 minutes!
3
2. Remove and keep blind cover .
3. Remove and keep the FIF protection cover
4. Plug the function module standard I/O
5. Press against the function module until it is snapped into place.
6. Assign the terminals of the function modules (PES: HF- shield connection by
connecting the shield to PE)
– Wiring of the terminals "controller inhibit (CINH)": ^ 33
E82ZAFS
E82ZAFS100
E82ZAFA
E82ZAFI
E82ZAFP
E82ZAFL
E82ZAFC
E82ZAFI
E82ZAFP
E82ZAFL
E82ZAFC
E82ZAFS
E82ZAFS100
8200vec278
4
.
5
on the interface FIF II.
L