Table des Matières
Publicité
GENERAL PURPOSE - PREFLIGHT CHECKS
Balance : This is a very important relationship between the CG location and the stall characteristics of an airplane or knife-edge
performance.
An aft CG will make the plane snap roll instead of making a clean stall. And your plane goes to down side at knife-edge flying instead
of straight.
To measure the CG location, measure 90 mm from the leading edge to wing center.
Control throws : Connect all your airborne equipment and turn on the radio system. Put your entire trim lever on the transmitter at the
neutral position. Then make all of the control surface at neutral position. Hold them with scotch tapes. After you set everything at the
neutral position, adjust the length of the pushrods for proper length. After connecting the pushrods to the servos and control surfaces,
check to be sure that the surfaces move the amounts properly which is shown here.
Wing weight balance : After adjusting the down and side thrust of the motor, adjust the wing balance. Fly your model straight and
level. Pull up and see which way your planes goes. If it goes to the right, put some weight on the left wing.
Notice internet en couleur ! : La notice est téléchargeable
sur notre site sur la fiche produit du modèle, à la section
DOC-NOTICE.
Internet construction guide in color ! : The manual is downloadable on our
website on the product page, section DOCUMENTATION.
Notice Ecotop - Page 30 - Pilatus PC-6 Turbo Porter 2.07m ARF
NOTES
NOTES
Bons vols...
Good flights...
Publicité
Table des Matières
