Section 5 − Installation; Selecting A Location - Miller 22A Manuel D'utilisation

5-1. Selecting A Location

OM-193472 Page 14
SECTION 5 − INSTALLATION
1
5
!
Do not move or operate unit where it could tip.
3
4
2
6
!
Do not put feeder where
welding wire hits cylinder.
.
Wire feeder shown is repre-
sentative only and may not
reflect actual unit.
1 Wire Feeder
2 Rubber Feet
Choose slot that allows all rubber
feet to sit securely on top of welding
power source.
3 Wire Spool/Reel
4 Gas Cylinder w/Hose And
Regulator (Customer
Supplied)
.
Shielding gas pressure not to
exceed 100 psi (689 kPa).
5 Welding Power Source
6 Running Gear
loc_feeder/cart 2015-05