Miller 22A Manuel D'utilisation page 35

.
Base selection of drive rolls upon the following recommended usages:
1. V-Grooved rolls for hard wire.
2. U-Grooved rolls for soft and soft shelled cored wires.
3. U-Cogged rolls for extremely soft shelled wires (usually hard surfacing types).
4. V-Knurled rolls for hard shelled cored wires.
5. Drive roll types may be mixed to suit particular requirements (example:
V-Knurled roll in combination with U-Grooved).
Wire Diameter
Fraction Decimal
.023/.025 in. .023/.025 in.
.030 in. .030 in.
.035 in. .035 in.
.040 in. .040 in.
.045 in. .045 in.
.052 in. .052 in.
1/16 in. .062 in.
.035 in. .035 in.
.045 in. .045 in.
.052 in. .052 in.
1/16 in. .062 in.
5/64 in. .079 in.
.035 in. .035 in.
.045 in. .045 in.
.052 in. .052 in.
1/16 in. .062 in.
.068-.072 in. .068-.072 in.
5/64 in. .079 in.
.045 in. .045 in.
.052 in. .052 in.
1/16 in. .062 in.
5/64 in. .079 in.
Table 9-1. Drive Roll And Wire Guide Kits (2 Drive Roll)
Kit No.
Metric
0.6 mm 087131
0.8 mm 079594
0.9 mm 079595
1.0 mm 161189
1.2 mm 079596
1.3 mm 079597
1.6 mm 079598
0.9 mm 044749
1.2 mm 079599
1.3 mm 079600
1.6 mm 079601
2.0 mm 079602
0.9 mm 079606
1.2 mm 079607
1.3 mm 079608
1.6 mm 079609
1.8 mm 089984
2.0 mm 079610
1.2 mm 083318
1.3 mm 083317
1.6 mm 079614
2.0 mm 079615
Drive Roll
Part No. Type
087130 V-Grooved
053695 V-Grooved
053700 V-Grooved
053696 V-Grooved
053697 V-Grooved
053698 V-Grooved
053699 V-Grooved
072000 U-Grooved
053701 U-Grooved
053702 U-Grooved
053706 U-Grooved
053704 U-Grooved
132958 V-Knurled
132957 V-Knurled
132956 V-Knurled
132955 V-Knurled
132959 V-Knurled
132960 V-Knurled
083489 U-Cogged
083490 U-Cogged
053708 U-Cogged
053710 U-Cogged
Inlet
Wire Guide
056192
056192
056192
056192
056193
056193
056195
056192
056193
056193
056195
056195
056192
056193
056193
056195
056195
056195
056193
056193
056195
056195
S-0157-C
OM-193472 Page 31