Equipment Connection Diagrams; 14-Pin Plug, Shielding Gas And Optional Volt Sense Lead - Miller 22A Manuel D'utilisation

5-2. Equipment Connection Diagrams

1
3
2

5-3. 14-Pin Plug, Shielding Gas And Optional Volt Sense Lead

3
2
Tools Needed:
5/8, 11/16 in.
4
115VAC
Contactor
4
1
4
1 CV Welding Power Source
With 24 VAC Power
2 CV Welding Power Source
Without 24 VAC Power
3 115 Volts AC /24 Volts AC
Power Adapter
4 14-Pin Control Cord
5 Weld Cable (Required)
6 Work
6
5
6
5
1 Gas Hose With 5/8-18 Right-
hand Thread Fittings
(Customer Supplied)
.
Shielding gas pressure not to
exceed 100 PSI (689 kPa).
2 14 Pin Plug PLG2
Use plug to make connection to
welding power source.
3 Optional Volt Sense Lead
(Part Of Meter Option)
!
Weld voltage is present at
voltage sensing clamp
when wire feeder and weld-
ing power source are on.
This condition exists even if
wire feeder lights and
meters are off.
Turn off wire feeder or weld-
ing power source before
handling or moving voltage
sensing clamp.
Connect to work.
4 Power Switch
802 349-A
OM-193472 Page 15