Recommended Cutting Equipment For Canada - RedMax GZ380 Manuel D'instructions

Recommended original and replacement bar and chain combinations
for USA
Following is a list of recommended cutting equipment for the chain saw model RedMax GZ380.
The combinations of power head, bar and chain have been tested and found to be in accor-
dance with the kickback and vibration requirements of ANSI B175.1- -2000.
The guide bar nose radius is determined by either the maximum number of teeth in the
nose sprocket or the corresponding maximum nose radius of a solid bar.
The following list is the chain saw manufacturers recommendations. There may be other com-
binations available, which will also achieve kickback reduction. As we are listing the maximum
guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For
guide bars of the same length, all sprocket- -nose guide bars of the same pitch and having the
same number of sprocket teeth may be considered to have equivalent kickback energy. A hard
nose bar having the same length and nose radius as a sprocket- -nose bar may be considered
to have equivalent or less kickback energy than the sprocket- -nose bar.
Chain saw model RedMax GZ380 met the kickback performance requirements of ANSI
B175.1- -2000 when tested with the combinations of bars and saw chains listed below. The
saw chain Oregon 91VG is also classified as a low kickback saw chain since it met the
requirements for low kickback saw chain outlined in ANSI B175.1- -2000. We recommend to
use only the listed combinations of bars and chains for chain saw model RedMax GZ380.
Other chain saw models may not meet the kickback requirements when equipped with the
listed bar and chain combinations.

Recommended cutting equipment for Canada

The following is a list of recommended cutting equipment for Class 1A and 1B Chain saws.
The combinations of powerhead, bar and chain meet all requirements outlined in the CSA
Z62.1- -95 Chain Saws and Z62.3- -96 Chain Saw Kickback Standards.
The guide bar nose radius is determined by either the maximum number of teeth in the
nose sprocket or the corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller
nose radius than in our list. For guide bars of the same length, all sprocket- -nose guide bars
of the same pitch and having the same number of sprocket teeth may be considered to
have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket- -nose bar may be
considered to have equivalent or less kickback energy than the sprocket- -nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low- -
Kickback Saw Chains" which are available at your dealer.
Bar
Length, Pitch, Thickness of drive Max. nose
inches inch links, inch/ mm
16 3/8 0.050/1.3
inch
91VG 5/32
115391326 Rev. 3 1/31/11
TECHNICAL DATA
radius Part no.
7T 5741361-01
80° 30°
Chain
Drive link
Type Count
91VG 57
inch/mm
0° 0.025"/0.65
English--- 28