DBI SALA NANO-LOK 3500224 Manuel D'instructions page 16

table 1 - Nano-Lok Edge™ Self Retracting Lanyards Inspection Schedule and Checklist
Web Lifeline
Models
Lanyard End Figure 1 and Section 7.2 identify the Lanyard End Connectors that may be included
Connectors on your Nano-Lok Edge SRL model. Inspect all Snap Hooks and Rebar Hooks for signs
(Figure 1 and of damage, corrosion, and proper working condition. Where present: swivels should
Section 7.2) rotate freely and gates should open, close, lock and unlock properly.
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Cut
Frayed
Heavily
Soiled
Welding
Burns
The webbing material must
be free of frayed, cut, or
broken fibers. Check for
tears, abrasions, mold,
burns, or discoloration, etc.
The webbing must be free
of knots, excessive soiling,
heavy paint buildup, and rust
staining. Check for chemical
or heat damage indicated
by brown, discolored, or
brittle areas. Check for
ultraviolet damage indicated
by discoloration and the
presence of splinters or
slivers on the webbing
surface. All of the above
factors are known to reduce
webbing strength. Inspect
stitching for pulled or cut
stitches. Broken stitches may
be an indication the energy
absorbing lanyard or energy
absorber component has been
impact loaded and must be
removed from service.
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
16